Battery - The Battery is a lithium ion battery. When you first get your kit you should charge your batteries completely. It will take approximately 2 hours to fully charge your batteries. Your battery will last for 5-10 hours of use, depending on your usage habits.
Switch - Your batteries are equipped with a 5-click off/off feature. Press the Switch 5 times quickly within 2 seconds, your battery will flash, it will now be off. Press it again 5 times again to turn it back on.
Atomizer - The atomizer heats the liquid contained in the cartridge to produce the vapour. When you first get your atomizer you will have to prime it. If you look into the top of the atomizer, you will see a post. One or two drops of liquid on the post will suffice. It is very important to not let your atomizer run dry. Running it dry will burn out your atomizer.
Wick - The Wick can be changed when it gets too dirty or you get burnt tasting. Use tweezers to remove the wick by grabbing all the wick fibers and pull the wick straight out of the hole. Replace cleaned or new wick using tweezers by pushing the wick into the hole. Caution: Do not force the wick all of the way to the top as there should be enough length of the wick exposed to touch the atomizer coil.
Cartridge - The Cartridge will hold approximately 1.1ml of liquid. To fill the cartridge, you can remove the silicone cap on the end of the cartridge and drip liquid directly into the chamber but we recommend using a needle tip bottle to prevent damaging the end cap. Continue filling the cartridge until the chamber is approximately 3/4 full.
Charger - The Charger cable can be plugged into a USB port on your computer or into the USB wall adapter that plugs into your standard household socket. When screwing the battery into the charger it should be snug but do not over tighten.The light on the cable will turn red and remain red while it is charging your battery. Once fully charged it will turn green. Charging generally takes about 1.5-2.5 hours on the wall charger but could take longer when connected to the computer or other USB port.
Care and Maintenance - This is an electronic device; do not use water to clean any of the electrical connectors. Every day, clean the atomizer threading, the battery threading and the inside threading on the charger with a piece of dry paper towel. Every 2-3 days your Imist/2 atomizer should be cleaned with (USP) isopropyl alcohol Use a small brush to take off any residue that has built up on the heating coil. NOTE: Do not damage or deform the coils of the atomizer. Damaging or deforming the coil may cause
a break or short which would permanently damage your atomizer as well as possible damage to the battery.
